The cross-section of extrusion products must be constant at any point along their length, with the exception of all those with non-uniform or irregular shapes.
In the extrusion line, most of the products that are obtained require subsequent processes to adequately obtain bags from tubular film or to form the joint through cutting and sealing. Thermoplastic sheets and films are produced by numerous processes, the most important of which are those based on the extrusion process.
The plastic sheet extrusion line is used in laminating plastic raw materials, leaving them at the right point to be transformed. Depending on the materials, their configurations, the amount of material to be delivered, etc., appropriate extruders should be used for such purposes.

The plasticized material passes through a system of metal filters in order to eliminate solid contaminants that the raw material may contain. The filtering system can be part of the extruder or constitute a separate unit placed at the end of it. This process is used to make plastic sheets or films that are too thick to blow.
Main components of a typical board extrusion line
The head or flat die is considered the most important piece of the flat sheet extrusion line, since it has the function of taking the flow of plasticized materials coming from the extruder, and forming the sheet in fractions of a second giving the main characteristics to the formed material such as the desired width, thickness range, uniformity in the product profile, homogeneity in the distribution of the plasticized material, and more.
The most important thing to note is that if the head or die is not efficient in the effective formation of the product, it is almost impossible to correct the deficiencies originated in this head. There are three types of dice used: T-shaped, clothespin, and fishtail. The dies are used in guiding and reorienting the flow of the molten polymer from the extruder.
In both types of dies a constant and uniform flow must be ensured through the entire cross-sectional area of the die. Sheets and films are produced in various thicknesses by conventional extrusion, using a die whose opening is in the form of a thin slit. The slit can be up to 3 m long with a width close to 0.04 mm.
One difficulty of the extrusion method is the uniformity of thickness across the width of the material. This is due to the drastic change in shape that the polymer melts during its passage through the die and to variations in temperature and pressure in the die.
Sheet and Film Product Applications
The sheets and films obtained by flat die extrusion using the board extrusion line have a large number of applications: plastic films in general, stretch film for use in packaging, bathroom curtains, barrier materials for packaging of food products, sheets for thermoforming of disposable products, thermoformed surfaces, dressings and covering elements for magnetic tapes, plastics for coating on others, blister for medicines, exterior covers of buildings, exhibition panels, plastic identification cards and more.